WHY VEP Apparat®
WHAT IS VEP Apparat®
WHO IS VEP Apparat® FOR
VEP Apparat® TRAINING
VEP Apparat® ADVANTAGES
TECHNICAL DATA
USING VEP Apparat®
ADDITIONAL INSTRUCTIONS
ORDERING
CONTACT
HOME

USING VEP

Preparing to use VEP

1. Before using the apparatus, trim with scissors pubic hair to 0.5mm or less around penis base.

2. Check and tighten the apparatus head nut and valve.

3. Select from the set of sealing rings the appropriate one so that user can easily take out the penis in full erection. If the size of penis is bigger than biggest aperture of sealing ring, it should not be used al all.

Lean the handle of the apparatus against the tube (starting position]. Shift the ring towards the apparatus' head in order to free the place for putting the rubber ring at the neck of tube.

Select one of rubber strip set for tightening the penis base starting from the largest one. If the erection ceases tries should be repeated with shorter rubber ring, until achieving the good result. The quality of the erection depends on the tightness of the rubber ring so two elastic rings can be simultaneously slipped onto the base of the penis.

Insert the ball-shaped end of rubber strip through the slot to make a rubber ring.

Slip the rubber ring onto the neck of the tube as follows:
Place the wide aperture of the plastic cone on a flat surface and then place the rubber ring on the top of plastic cone so that the connection with ends is in direction of the cone's channel. Roll the rubber along the cone until it is placed at its widest part. Plastic cone with the rubber ring place into the tube so that the top of cone is directed towards the inside of apparatus and the point of connection is in the direction of the sticker with numbers. Keeping the plastic cone tight in the apparatus move (roll) the rubber to slip on the base of the tube neck, taking care that rubber ends are not tangled up and ball is towards the users face. During the placing procedure the rubber must be dry in order not to open.

Take out the plastic cone from the apparatus and place the sealing ring.

Apply some gel from the jar onto the skin surrounding the base of the penis, where the device is placed.

Note!
Before the first use, press the pump several times in order to obtain the functioning of the pump.







7e

Using VEP

Holding the apparatus in this position (handle pointed downwards) insert the penis into the tube, shaking the tube al the same time to enable the penis to stretch out fully. Press the tube against the base of penis and start to pump (3-4 times, and 5 sec. break).

When full erection is achieved stop pumping, leave the pump and with the same hand immediately shift the handle towards the clip as far as it will go, holding with the other hand apparatus and pressing it against the penis base all the time. In this way the rubber ring is slipped from the tube neck to penis base. A ring of bulging tissue will appear at the penis base tightened by a rubber ring and this should be considered a natural phenomenon. The tightening sensation may be felt at the beginning of the use of the apparatus. However, he will get used to this and will not feel it at all after a certain time.

In order to take the penis out of the tube, turn the valve anticlockwise, then take the penis out, and start sexual intercourse, which can last up to 30 minutes.

WARNING: THE RUBBER RING MUST NOT BE KEPT ON THE BASE OF THE PENIS LONGER THAN 30 MINUTES.

At the end of sexual intercourse, i.e. just before ejaculating, take hold of the ball-shaped end of the rubber ring at the base of the penis and pull it. In this way, the rubber ring will open and thus enable ejaculation without having to lake the penis out of the vagina.

The whole procedure can be repeated after a break of 15 min.